Sand & Sludge Nozzle

Fabricated from a solid block of stainlees steel, Sand and Sludge Nozzles offer flat surfaces for gluiding over heavy dirt & debris deposits in large diameter pipes. A double beveled & rounded front on the Sand and Sludge Nozzles assists in climbing over debris to allow for the high pressure rear water streams to breakup and flush debris from the pipe.



Four Jets, 2 Fan Jets & 2 Zero Degree Jets provide pipe bottom cleaning power from a 7 pound nozzle base.

Medium weight nozzle

A medium weight nozzle designed to clean the bottom of large diameter pipes with 4 rear jets.

Large Diameter Pipe Cleaning Nozzles

Above: Dragon Jet Nozzle, 16 Lb. - 4 Rear Jets
Below: Sand & Sludge Nozzle, 7 LB. - 4 Rear Jets

The flat shape design allows for the nozzle to rollover in a pipe without the loss of cleaning efficiency. High pressure water leaves the Sand & Sludge Nozzles through four replaceable rear mounted jets, two 0° degree nozzles and two 45° degree nozzles. A Drain Jet Extension (with a minimum length of 9 inches) should always be used for nozzle connection to protect the high pressure water hose against abrasive damage from flying debris. In addition, Drain Jet Extensions provide added weight to keep the nozzle on the bottom of the pipe and to prevent the nozzle from turning back (u-turns) within the pipe.

US Jetting Storm Drain & Large Diameter Pipe Cleaning Nozzles

From left to right: Sand & Sludge (SAS) Nozzle, Grenade Bomb Nozzle, PDR Nozzle & Dragon Jet.